How to Operate Liming Hammer Crusher?

1. In order to ensure the maximum yield of hammer crusher, charging must continuously even distribution of the rolls.

2. The operator should be regularly check whether the material mouth had blocked phenomenon, and in the motor stopped working to stop before feeding, when material completely dropped, the roll of a power outage, motivation may idling.

3. If the roller along the length direction feeding is not even, roller surface not only faster, and each point wear is uneven and will appear ring groove, the normal work have been destroyed and broken the uneven size products. Therefore, in addition to crushing the roll crusher, outside of finely roll crusher, usually a feeder, to ensure that the feeding successive and even, and the length of the feeder with roller length equal, makes the feeding length direction along the roller uniform.

4. Reasonable maintenance and correct operation can ensure long-term continuous work, reduce stop time, only normal management and every day to check the normal work of the roll crusher, to prevent failure, and ensure that the work continuously.

Therefore, the operator should pay attention to the following items:

1. pay attention to all parts, such as the discovery of bolts shall be immediately screw loose;
2. must firstly start roller crusher before working, wait for normal speed, and then feed materials;
3. check the material regularly, such as the discovery of a mouth clogged, it should be cleared;
4. check the vulnerable wear parts, always be worn parts; replace
5. not make machines produced load;
6. bear oiling in time, do not make in the place of oil bearing;
7. control the bearing’s temperature, it should be lower than or around 25 to 30 ℃;
8. remove dust and material from chassis activities device.